| |
APPLICATIONS
-
Use appropriate clothes,
protective gloves and protective glasses to avoid any possible
splash.
-
All surfaces to receive
application must be clean, smooth and free of loose debris, dirt and
dust, efflorescence, grease, oils, curing agents and cleaning
solutions. Ensure that all surfaces are smooth and free of any
irregularities. Repair all cracks with the appropriate patching
material for the existing substrate.
-
Color coat should be approximately
1/8 thick. Hand trowel application over a premium light color cement
brown coat.
-
Add approximately 16 oz of water
to full bucket of Marmix and mix it with an electric mixer for about
8 minutes until it is smooth and free of lumps. The brown coat or
the surface that will be applied on, should be very smooth, clean
and dry. By using a steel trowel, apply over a smooth brown coat by
spreading on evenly and glaze it well. After approximately 15
minutes, glaze it again for smooth finish. Wet the trowel with a
sponge during reglazing.
SAFETY:
Avoid contact with eyes or prolonged
contact with skin. Wash thoroughly after handling. In case of eye
contact, flush immediately with running water for at least 15 minutes.
Consult a physician immediately. Do not take internally. Be sure to
provide adequate ventilation in enclosed areas. Use of an approved
respirator is recommended.
CLEANING:
Cleaning may be accomplished with
water immediately after use.
COVERAGE:
A full 50 lbs bucket of Marmix covers
approximately 10 yards of area, depending on the application and
smoothness of the surface that is applied on.
AREA OF USE:
Marmix plaster/stucco may be applied
to following substrates.
1. Brown Coat
2. Masonry
3. Poured-in-place and/or Tilt-up concrete
4. Glass
5. Metal
6. Plastic
7. Foam
8. Wood
9. Drywall
Basically on any smooth surfaces.
PACKING AND STORAGE:
50 lbs plastic buckets.
Store buckets in a cool, dry location. Do not store in direct contact
with the ground and/or concrete. Store out of direct sunlight.
Unopened buckets can be stored up 1 year, protected from heat and
freeze.
DRYING PERIOD:
Drying time may vary to climatic
conditions, but should not take less 24 hours at an ambient and
surface temperature of 70 F (21 C). Variations humidity may prolong
drying time. All freshly applied material must be protected by an
approved protective system from inclement weather until fully dry.
|
|
